Jump to content

BlTouch randomly crashes and its not the cable - General Hangout & Discussions - InviteHawk - Your Only Source for Free Torrent Invites

Buy, Sell, Trade or Find Free Torrent Invites for Private Torrent Trackers Such As redacted, blutopia, losslessclub, femdomcult, filelist, Chdbits, Uhdbits, empornium, iptorrents, hdbits, gazellegames, animebytes, privatehd, myspleen, torrentleech, morethantv, bibliotik, alpharatio, blady, passthepopcorn, brokenstones, pornbay, cgpeers, cinemageddon, broadcasthenet, learnbits, torrentseeds, beyondhd, cinemaz, u2.dmhy, Karagarga, PTerclub, Nyaa.si, Polishtracker etc.

BlTouch randomly crashes and its not the cable


Recommended Posts

Hello,
I know, i’m not the first one, but i can’t get a bltouch to work properly and since i ruled out every other possibility i ask here for help.

So, randomly, like every fouth to every 40th attempt a probing fails and ends in a headcrash.
Setup:

Anet Et4 (i know)
original BLTouch V3.1
Raspberry Pi3B V1.2
Mainsail OS
So, since adding a BLTouch to the Printerboard is a little difficult i added the Raspberry as MCU and drive it from there. Controlpin works fine. As Sensorpin i use GPIO0 or GPIO1 since they have an inbuild pullup.

After initial setup i receive several crashes. So i

build a connectorcable from a CAT6 cable → same result
switched to the probe-pin from my Anet Board → same result
ordered a new BLTouch → same result
So in general it’s working, but expecting a crash before every print makes it unusable. In the Log you will find a working manual check, a working home command and during probe_accuracy the thrid attempt failed.

How could i debug this futher?
Thanks for your help!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Customer Reviews

  • Similar Topics

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.